Featured image credit: SpaceX
Lift Off Time
|June 18, 2022 – 14:19 UTC | 07:19 PDT|
|SARah 1 & Rideshares|
|Falcon 9 Block 5, B1071-3; 62.05 day turnaround time|
|Space Launch Complex 4E (SLC-4E), Vandenberg Space Force Base, California, USA|
|~2,200 kg (~4,900 lb)|
Where did the satellites go?
|750 km circular Sun-Sychnornous Orbit at 98.4°|
Did they attempt to recover the first stage?
Where did the first stage land?
|Landing Zone 4 (LZ-4)|
Did they attempt to recover the fairings?
|The fairing halves will be recovered from the water ~633 km downrange by NRC Quest|
Were these fairings new?
This was the:
|– 159th Falcon 9 launch
– 97th Falcon 9 flight with a flight proven booster
– 101st re-flight of a booster
– 23rd re-flight of a booster in 2022
– 125th booster landing
– 51st consecutive landing (a record)
– 25th launch for SpaceX in 2022
– 24th SpaceX launch from SLC-4E
– 66th orbital launch attempt of 2022 (64th successful)
Where to watch
How Did It Go?
SpaceX successfully launched the SARah 1 radar satellite for Bundeswehr on their Falcon 9 Block 5. Having lifted off from Space Launch Complex 4 East, at the Vandenberg Space Force base, in California, the Falcon 9 placed the SARah 1 satellite and other rideshare satellites into a 750 km Sun-Synchronous Orbit.
What Is SARah 1?
The SARah 1 satellite is a radar reconnaissance satellite that is built by Airbus Defense and Space and operated by the German armed forces, called Bundeswehr. The satellite is set to replace the aging SAR-Lupe constellation, which, as the name implies, is a Synthetic Aperture Radar (SAR) constellation that the German government currently uses for reconnaissance.
The SAR-Lupe constellation will be replaced by the SARah1, SARah 2, and SARah 3 satellites; The first satellite, SARah 1, will be equipped with a phased array antenna which will increase the resolution of the SAR constellation, past that of SAR-Lupe. SARah 2 and SARah 3 will be two “reflector antenna” satellites, meaning they will fly in formation with SARah 1 to increase the resolution of the constellation.
SARah 1 is equipped with two large solar cells and batteries to provide power to the spacecraft. It is unknown what kind of propulsion the satellite uses.
SARah 1 is joined by several other ride share satellites; however, none of these have been announced.
What Is Falcon 9 Block 5?
The Falcon 9 Block 5 is SpaceX’s partially reusable two-stage medium-lift launch vehicle. The vehicle consists of a reusable first stage, an expendable second stage, and, when in payload configuration, a pair of reusable fairing halves.
The Falcon 9 first stage contains 9 Merlin 1D+ sea level engines. Each engine uses an open gas generator cycle and runs on RP-1 and liquid oxygen (LOx). Each engine produces 845 kN of thrust at sea level, with a specific impulse (ISP) of 285 seconds, and 934 kN in a vacuum with an ISP of 313 seconds. Due to the powerful nature of the engine, and the large amount of them, the Falcon 9 first stage is able to lose an engine right off the pad, or up to two later in flight, and be able to successfully place the payload into orbit .
The Merlin engines are ignited by triethylaluminum and triethylborane (TEA-TEB), which instantaneously burst into flames when mixed in the presence of oxygen. During static fire and launch the TEA-TEB is provided by the ground service equipment. However, as the Falcon 9 first stage is able to propulsively land, three of the Merlin engines (E1, E5, and E9) contain TEA-TEB canisters to relight for the boost back, reentry, and landing burns.
The Falcon 9 second stage is the only expendable part of the Falcon 9. It contains a singular MVacD engine that produces 992 kN of thrust and an ISP of 348 seconds. The second stage is capable of doing several burns, allowing the Falcon 9 to put payloads in several different orbits.
For missions with many burns and/or long coasts between burns, the second stage is able to be equipped with a mission extension package. When the second stage has this package it has a gray strip, which helps keep the RP-1 warm, an increased number of composite-overwrapped pressure vessels (COPVs) for pressurization control, and additional TEA-TEB.
Falcon 9 Booster
The booster that supported the SARah 1 mission is B1071. This booster had supported two previous flights, making its designation for this mission B1071-3; this changed to B1071-4 upon successful landing
Following stage separation, the Falcon 9 conducted three burns. These burns softly touched down the booster on SpaceX’s landing zone LZ-4.
Falcon 9 Fairings
The Falcon 9’s fairing consists of two dissimilar reusable halves. The first half (the half that faces away from the transport erector) is called the active half, and houses the pneumatics for the separation system. The other fairing half is called the passive half. As the name implies, this half plays a purely passive role in the fairing separation process, as it relies on the pneumatics from the active half.
Both fairing halves are equipped with cold gas thrusters and a parafoil which are used to softly touch down the fairing half in the ocean. SpaceX used to attempt to catch the fairing halves, however, at the end of 2020 this program was canceled due to safety risks and a low success rate. On SARah 1, SpaceX attempted to recover the fairing halves from the water with their recovery vessel NRC Quest.
In 2021, SpaceX started flying a new version of the Falcon 9 fairing. The new “upgraded” version has vents only at the top of each fairing half, by the gap between the halves, whereas the old version had vents placed spread equidistantly around the base of the fairing. Moving the vents decreases the chance of water getting into the fairing, making the chance of a successful scoop significantly higher.
SARah 1 Countdown
All times are approximate
|00:38:00||SpaceX Launch Director verifies go for propellant load|
|00:35:00||RP-1 (rocket grade kerosene) loading underway|
|00:35:00||1st stage LOX (liquid oxygen) loading underway|
|00:16:00||2nd stage LOX loading underway|
|00:07:00||Falcon 9 begins engine chill prior to launch|
|00:01:00||Command flight computer to begin final prelaunch checks|
|00:01:00||Propelant tank pressurization to flight pressure begins|
|00:00:45||SpaceX Launch Director verifies go for launch|
|00:00:03||Engine controller commands engine ignition sequence to start|
|00:00:00||Falcon 9 liftoff|
SARah 1 Launch and Landing
All times are approximate
|00:01:12||Max Q (moment of peak mechanical stress on the rocket)|
|00:02:17||1st stage main engine cutoff (MECO)|
|00:02:20||1st and 2nd stages separate|
|00:02:34||1st stage boostback burn begins|
|00:03:21||1st stage boostback burn complete|
|00:06:09||1st stage entry burn begins|
|00:06:31||1st stage entry burn complete|
|00:07:25||1st stage landing burn begins|
|00:07:56||1st stage lands on Landing Zone 4|